Electronics Corp.
KIT 750P CONTENTS
PHOTO-ETCH KIT FOR PRINTED CIRCUITS
KIT 750P IS A PRINTED CIRCUIT KIT TO BE USED TO MAKE FINE RESOLUTION PRINTED CIRCUIT BOARDS BY MEANS OF A PHOTOGRAPHIC PROCESS.
CONTENTS
1. BLACK PLASTIC to protect underside from light
2. 4" x 6" GLASS ( 2 PCS ) to construct an exposure frame
3. FOUR METAL SPRING CLIPS to hold glass and positive firmly against the board
4. THREE 2-SIDED SENSITIZED BOARDS ( 2 Boards 3x4.5" 1 board 4x6") to make printed circuit boards
5. PHOTO-FLOOD LAMP ( PC557 ) to expose board
6. DEVELOPER ( D3-6 ) to wash away exposed resist
7. TWO PLASTIC TRAYS to hold photo resist developer and etchant
8. ETCHANT ( PC199-6 ) to etch away unwanted copper
9. 2 FOAM SWABS to wipe down the boards
10. 040" DRILL BIT ( PC300-60 ) to drill holes for components and registration holes
11. SCOURING PAD ( PC-SB ) to remove photo resist after board is finished
12. FLANGED PINS ( B6602-10 ) for registration of positive artwork
13. PC 50A REUSABLE EXPOSURE GUIDE to determine proper time and exposure rate
14. PROTECTIVE GLOVES to protect your hands while handling boards and chemicals
15. INSTRUCTION SHEET to provide instructions on the recommended method to make a printed circuit board
631-563-3388
631-563-3389
110 Keyland Court, Bohemia, NY 11716
800-878-7227
General Information: injectorall@mindspring.com
Copyright © 2003 Injectorall Electronics Corp.
visitors to this page since Last Modified: November 18, 2003