Electronics Corp.
KIT 850 CONTENTS
PHOTO-ETCH KIT FOR PRINTED CIRCUITS
KIT 850 IS A PRINTED CIRCUIT KIT TO BE USED TO MAKE FINE RESOLUTION PRINTED CIRCUIT BOARDS BY MEANS OF A PHOTOGRAPHIC PROCESS. THIS KIT UTILIZES A POSITIVE WORKING PHOTO RESIST AND A TEST POSITIVE IS INCLUDED FOR PRACTICE IN MAKING YOUR FIRST BOARD.
CONTENTS
1. INJECTORALL TEST POSITIVE for practice in making your first board
2. 4" x 6" GLASS 2 pcs. to construct an exposure frame
3. FOUR METAL SPRING CLIPS to hold glass and positive firmly against the board
4. THREE 1-SIDED SENSITIZED BOARDS (2 boards 3x4.5" 1 board 4x6") to make printed circuit boards
5. PHOTO-FLOOD LAMP ( PC557 ) to expose board
6. DEVELOPER ( D3-6 ) to wash away exposed resist
7. TWO PLASTIC TRAYS to hold photo resist developer and etchant
8. ETCHANT ( PC199-6 ) to etch away unwanted copper
9. TWO FOAM SWABS to wipe down the boards
10. SCOURING PAD to remove photo resist after board is finished
11. .040" DRILL BIT ( PC300-60 ) to drill holes for components
12. PC 50A REUSABLE EXPOSURE GUIDE to determine proper time and exposure rate
13. PROTECTIVE GLOVES to protect your hands while handling boards and chemicals
14. INSTRUCTION SHEET to provide instructions on the recommended method to make a printed circuit board
631-563-3388
631-563-3389
110 Keyland Court, Bohemia, NY 11716
800-878-7227
General Information: injectorall@mindspring.com
Copyright © 2003 Injectorall Electronics Corp.
visitors to this page since Last Modified: October 13, 2003